|
|
Post by illbebetter on Feb 12, 2013 8:40:38 GMT -5
Does anyone have a Innovate LC-1 Serial Cable I could borrow to set up a new wideband sensor controller?
Thanks, Mike.
|
|
|
|
Post by cr89x on Feb 12, 2013 22:13:08 GMT -5
I'm not sure if I have the serial cable. You shouldn't need it though unless you are trying to do something extremely "trick" and reprograming the controller.
|
|
|
|
Post by illbebetter on Feb 13, 2013 7:13:59 GMT -5
I looked up the pin outs for the cable. Turns out they are same as the one used by microsquirt. I made a cable. Since I am running an RX-7 afm plus an adj. fuel regulator, I figure I can use the software to adjust the narrow band output of the LC-1 to get the AFR to the right value(if needed).
|
|
|
|
Post by cr89x on Feb 13, 2013 19:53:57 GMT -5
You should have a Bosch wideband o2 sensor with the LC1 controller :/ I've never messed with the programming, just calibrated and ran.
|
|
